Specifications HR Coils  
 

Width Tolerances

Up to 200mm in slitted sizes with tolerance of 0.50mm

Above 200mm will be supplied in as rolled condition with mill edges & fish tail but without leader end as per following tolerances: 

Thickness in mm
Tolerance in mm
2.10  & above
-0.00,+ 6.00
Below 2.00
-0.00,+ 7.00

 Thickness Tolerances
Thickness in mm
Tolerance in mm
2.50  & above
0.05
2.10 to 2.45
0.06
1.80 to 2.00
0.07
Below 1.80
0.10

Camber
» As per BIS standard

Coil condition
»The edges shall be mill edges as agreed with the buyer
»In case of mill edge coils, the coil defects like burning & cracks will be within 5 mm from the      edge on  either side of the coil.
»The coils may be without tongue but with fish tail
»The coils will be supplied in as-rolled condition without any skin passing, oiling, annealing &  normalising etc. unless otherwise specified by the  purchaser.

Coil ID
» 510 m

 
    « Back
   
 
Home | About us | Products | Infrastrucutre | Quality | Feedback | Contact us

Copyright © 2006-07 AverySteel.com. All Rights Reserved.